Kitchen Cabinets Crown Molding Installation Instructions

Use one long strip for a row of cabinets.

Kitchen cabinets crown molding installation instructions. 24 Using a level make sure each cabinet is level and each face frame front of the cabinet is flush with the adjacent cabinet. Cut the other three sides in the same way. Using a nail gun nail the crown.

Make sure the cabinets are square by placing a framing square inside or outside of the cabinet. Using frameless cabinets means that a sub-crown molding will always2 ½have to be screwed to the top of the cabinet case to attach the crown molding to. Provide a nailing surface for crown moulding by attaching solid wood mounting strips to the top edges of the cabinets.

Finally the crown is lifted up and installed level and square to the backing pieces. You can always trim off the excess after installation. A pry bar and shims can be used temporarily to get everything level and plumb.

Unless there is ample room above the doors to attach a crown molding or if you are using a very wide crown molding you will. Dry fit the crown molding by holding the front piece and a side piece against the front and side of the baseboard Image 1. Remove the molding from the cabinet and turn it upside down before placing it on the miter saw.

This means that there will be a little sliver of the unpainted piece of wood that will show through once the crown is added. File The Front And Side Stiles Of Your Cabinetry. Finish nails at the bottom flat and in the cove of the molding.

Sometimes a 316 cabinet skin is applied to the end. Cut strips of straight 34-in x 1-12-in wood to fit the front and sides of each cabinet. Cut your baseboards at a 45-degree angle.